Rena T-350 - Manual (Page 5)

GETTING ACQUAINTED
Section 1 – Getting Acquainted
Safety Precautions
THIS EQUIPMENT PRESENTS NO PROBLEM WHEN USED PROPERLY.
OBSERVE THE FOLLOWING SAFETY RULES WHEN OPERATING THE RENA
T-350 TABBER.
BEFORE USING THE T-350, YOU SHOULD READ THIS MANUAL CAREFULLY
AND FOLLOW THE RECOMMENDED PROCEDURES, SAFETY WARNINGS,
AND INSTRUCTIONS:
9 Keep hands, hair, and clothing clear of rollers and other moving parts.
9 Avoid touching moving parts or materials while the machine is in use. Before clearing a jam, be sure
machine mechanisms come to a stop.
9 Always turn off the machine before making adjustments, cleaning the machine, or performing any
maintenance covered in this manual.
9 Use the power cord supplied with the machine and plug it into a properly grounded wall outlet located
near the machine and easily accessible. Failure to properly ground the machine can result in sever
personal injury and/or fire.
9 The power cord and wall plug is the primary means of disconnecting the machine for the power
supply.
9 DO NOT use an adapter plug on the line cord or wall outlet.
9 DO NOT remove the ground pin from the line cord.
9 DO NOT route the power cord over sharp edges or trapped between furniture.
9 Avoid using wall outlets controlled by wall switches, or shared with other equipment.
9 Make sure there is no strain on the power cord caused by jamming between the equipment, walls or
furniture.
9 DO NOT remove covers. Covers enclose hazardous parts that should be accessed by a qualified
service representative. Report any damage of covers to your service representative.
9 This machine requires periodic maintenance. Contact your authorized service representative for
required service schedules.
9 To prevent overheating, do not cover the vent openings.
9 Use this equipment only for its intended purpose.
In addition, follow any specific occupational safety and health standards for your workplace or area.
This manual is intended solely for the use and information of Rena Systems Inc., its designated agents, customers, and
their employees. The information in this guide was obtained from several different sources that are deemed reliable by
all industry standards. To the best of our knowledge, that information is accurate in all respects. However, neither
Rena Systems Inc. nor any of its agents or employees shall be responsible for any inaccuracies contained herein.
RENA Systems Inc.
and “The Envelope Imaging Company” are registered trademarks of Rena Systems Inc.
All other trademarks are the property of their respective holders.
All rights reserved. No part of this manual may be reproduced or transmitted in any form or by any means, electronic
or mechanical, including photocopying, recording, or any information storage and retrieval system, without permission
in writing from Rena Systems Inc.
T-350 Operations Rev. 3/23/2009 5