Royal Vacuums UR30085 - Manual (Page 22)

4. maintenanCe
Familiarize yourself with these home maintenance tasks as proper use and care of your vacuum will ensure continued
cleaning effectiveness.
Any other servicing should be done by an authorized service representative.
11
CheCk bag indiCator
The indicator (L) will begin to show red as the filter bag fills with dirt. There are three
conditions that will cause the indicator to become completely red:
1. If the bag is full; change the bag.
2. If very fine materials have been picked up, clogging the bag pores; change
the bag.
3. If there is a blockage in the nozzle, hose, tools or at the bag opening;
remove the blockage (see “Clearing blockages” section).
3.4
L
Check filter bag from time to time. It is recommended
that you change the filter bag when dirt reaches the
dotted line. If more dirt than this accumulates, your
cleaner will not operate effectively.
Filter bag
When to replace
CAUTION
! !
Very fine materials, such as face powder or
cornstarch, may seal the filter bag and may cause it
to burst even though it is partially full of dirt. When the
cleaner is used to remove material of this nature,
change filter bag often.
What to buy
Use only genuine Royal ® bags with your vacuum.
When purchasing a new bag, ask for Royal ®
HEPA
Filtration Type Y disposable filter bags.
IMPORTANT
All new carpet has loose fibers which can fill the bag
quickly while vacuuming. This type of debris does
not activate the “Check bag” indicator available on
some models.
A Thermal Protector has been designed into your cleaner to protect it from overheating. When the
thermal protector activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Check fullness of filter bag; change if needed.
3. Inspect and remove blockage along the dirt path. This blockage may occur at the: nozzle inlet,
hose tube, dirt duct, hose, filter bag inlet, secondary filter, and final filter.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner needs servicing.
NOTICE
! !