SIGMA DP2x - Manual (Page 66)

65
AUTO BRACKETING
This function of the camera lets you take a sequence of pictures of
the same subject at three different exposure levels; Appropriate
Exposure, Under Exposure and Over Exposure. If it is difficult to
determine the proper exposure, please use this function.
1
Press the button.（The bracketing amount will change into
the Allocate function guide. The icon and the green
bracketing amount will be displayed on the left corner on the
LCD monitor.
• It is not possible to set the Auto Bracketing mode if you pop-up the built-in flash.
2
Use the buttons to set the bracketing amount.
●
It can be set in 1/3 stop increments up to ±3
3
Press the button to apply the exposure. (The bracketing amount will
change from green into white. The Allocate function guide will disappear.)
„ The camera will take three pictures in the following sequence; Appropriate
exposure, under exposure and over exposure.
„ The exposure bracketing can be used with 4 different modes.
P Mode ; Both shutter speed and aperture value will be changed.
A Mode ; Only shutter speed will be changed.
S Mode ; Only aperture value will be changed.
M Mode ; Only shutter speed will be changed.
TIP
•
Three frames will be taken continuously by pressing the shutter button.
When the Drive Mode is set to the Self Timer, only 1 frame will be taken
each time the shutter button is pressed.