Skutt FireBox8x6 LT - Manual (Page 21)

21
21
No Display
No display can be caused by a number of factors. The first thing to check obviously is to make sure the kiln
is plugged into the wall. If it seems secure, plug a light or radio into the same outlet to make sure the outlet is
live. If you find that it is not live, check your breaker. If you find that it has tripped reset it and then restart your
kiln. If it trips again call a Skutt technician for further troubleshooting.
There is a fuse holder on the side of your control box that holds a 0.5 amp fuse on the side of the box. Check
first to see if the fuse is fully engaged by pushing it in and turning it clockwise. If is seems secure twist it counter
clockwise and remove the fuse to see if it is good. If you find that it is bad, replace the fuse.
Pieces Over Fired
If you find that your pieces are over fired the first step is to press the down arrow to review the program
and make sure you ran the correct program for the materials you are firing. If it is correct, the next step is to
run another test fire. This will require a new test cone which you can find at most ceramic supply businesses.
Once you have completed your test fire and find that the kiln is over firing, the next step is to replace your
thermocouple.
Thermocouples will begin to slowly drift towards an over fire after a certain number of firings. This number will
vary depending on how hot you are firing your kiln and the amount of contaminants it is exposed to.
You can purchase a replacement thermocouple from your local distributor or directly from Skutt. There are
many different types and shapes of thermocouples so be sure to order one for your specific model. Instructions
for replacing a thermocouple can be found on our website in the video section at www.skutt.com.
Once you have replaced the thermocouple you will want to do another test fire. If you find the kiln is still over
firing call a Skutt Technician for further troubleshooting.
Pieces Under Fired
If you find that your pieces are under fired the first step is to press the down arrow to make sure you ran the
correct program for the materials you are firing. If it is correct, the next step is to run another test fire. This
will require a new test cone which you can find at most ceramic supply businesses. Once you have completed
your test fire and find that the kiln is under firing, the next step is to call a Skutt Technician for further
troubleshooting.
Warranty Information
Your kiln is covered for two years to be free of defects. Be sure to read you warranty card to see all of what is
covered. Be sure to register your warranty at www.skutt.com. The first step in any warranty claim is to call Skutt
at 866-858-0588. It is helpful to have the original packing material just in case we need to have you send the
unit back to Skutt for repairs.
Customer Service and Technical Support
PH: (503) 774-6000 [email protected]
t
roubleSHootinG