Skutt FireBox8x6 LT - Manual (Page 3)

3
3
Installation
• as with all electrical products, there is danger of electrical shock. use only properly sized and rated copper
wire when installing the power supply for your kiln. we recommend this work be done by a licensed electrician.
• kilns should always be located in a dry place to prevent electrical shock and corrosion.
• Follow all instructions for installation in this manual. always observe fire and building safety codes when
installing any skutt Product.
• If there are fire sprinklers located in the kiln room, make sure they are rated high enough so they will not be set
off when the kiln is at peak temperature. this should be tested with the kiln at peak temperature, the ventilation
system turned off, the sprinklers disabled and all doors and windows closed for maximum assurance during test.
• we recommend having a fire extinguisher rated for electrical fires easily accessible near the kiln.
• skutt ceramic Products Inc. will not assume liability for injury or damages caused by variations from the
instructions put forth in this manual.
• kilns get hot. observe all the instructions to ensure proper clearances from flammable or temperature sensitive
objects and living things.
• ventilation is key to maintaining a healthy work environment and proper room temperature. to ensure proper
ventilation and room temperature is maintained, consult a qualified hvac professional.
• the proper placement of thermocouples is crucial to the operation of all automatically controlled kilns. check all
thermocouples for damage and correct placement. thermocouples must protrude into the kiln chamber at least
1” to ensure an accurate reading.
• the power cord is sized correctly to handle the power for your particular kiln. never use an extension cord.
• make sure the power cord is routed in such a way as to not touch any portion of the kiln that gets hot.
• Be careful of pinch hazards when working on or assembling the kiln.
Maintenance
• always unplug the kiln before performing any repairs or general maintenance.
• use only skutt replacement parts. Improperly sourced parts may pose a hazard to you and your kiln and void
your warranty.
• never modify your kiln without first consulting skutt. Improper modifications may pose a hazard to you and
your kiln and void your warranty. Items such as alternative thermocouples, controllers, kiln coatings may ruin
your kiln if improperly installed or applied.
• replace any electrical components that are discolored, brittle, or corroded.
• Inspect all stainless steel bands to ensure they are tight. If they loosen, tighten them as much as possible to
prevent the band from slipping or flexing.
• The controller is a temperature control device. It is not a safety device.
• The maximum operating temperature is 100ºF (38ºC). This temperature refers to the room temperature
while the kiln is firing and does not pertain to the internal temperature of the kiln.
• The minimum operating temperature is 33ºF (1ºC).
• The controller contains static-sensitive parts that may be damaged by static electricity. Use caution to avoid
creating static that may damage the equipment. In areas where static electricity is common, or during dry
times of the year throughout the country, touch something metal before touching the controller to dis-
charge the static.
Precautions for the KilnMaster LT Controller
S
afety