Skutt KilnMaster Kilns Manufactured after March 1 2006 - Manual (Page 11)

11
s
tep
1
With a partner, pick the kiln up by the chest handles and rest it on top of the kiln slab (floor).
s
tep
2 On models with slabs that buckle to the kiln, reattach the buckles.
p
lace
p
eep
p
lugs
Place the white porcelain peep plugs into the peepholes of the kiln. Give them
a slight twist to lock them in. If you are not using an EnviroVent, EnviroVent 2,
or any other Downdraft vent, be sure to leave the top peep plug out when firing.
c
lean
Vacuum the inside of the kiln to remove dust, brick chips, and other foreign
matter from around the elements. Be sure not to get the hose too close to the
touch pad. Static electricity built up in the hose can damage the electronics.
t
est
f
iring
The test fire is very important and should not be skipped. It accomplishes several
objectives
Ensures the kiln is operating correctly and nothing was damaged in ●
shipping.
Burns off element oils and develops an oxide coating which will help ●
prolong the life of the elements.
l
OaDing
This first firing should be done with only kiln shelves. Place the first shelf layer
on one-inch (2.5 cm) posts above the slab. When loading ware in the kiln, it is
important to load it evenly to ensure proper ventilation. For a full description on
loading, see Appendix 4 — Loading Tips.
k
iln
W
ash
s
helves
Brush coat one side of each shelf with high fire kiln wash. Apply a thin coat of kiln wash in one direction, allow to
dry, and apply another thin coating in the opposite direction leaving a half inch (1.3 cm) margin from the outside
edge of the shelf. Allow to dry overnight. Never kiln wash the walls or lid of your kiln
!
p
lace
W
itness
c
Ones
A Cone 04 (1945˚F/1063˚C) is recommended for proper pre-oxidation of a new element. For more about cones,
see Appendix 3 — Heat Work (Cones). If your kiln is equipped with a lid lifter, be sure to latch the lid shut.
t
est
F
ire
t
he
k
iln
Follow the Cone Fire Mode programming instructions found in the Programming section of this manual to run a
Cone 04 , Medium Speed program with No Hold time and No Preheat. Be sure to turn your downdraft
vent on if one is installed or otherwise prop the lid to 1000º F (538º C) to allow smoke from oils on the elements
to escape. After the kiln has cooled to room temperature, unload the kiln and inspect the cones. If the Cones
are satisfactory you are ready to begin using the kiln. If there is a problem with the cones see the section on fine
tuning your kiln on page 15.
s
et
-
uP