Skutt KilnMaster Kilns Manufactured after March 1 2006 - Manual (Page 54)

54
a
ppendix
9 -
p
riMarY
d
isplaY
M
essages
Messages displayed while accessing menu functions are described in the menu section of the manual. They are not
listed below.
ALRM
The controller is asking for an alarm temperature to be entered between 0 ° and 9999 ° that will alert the operator
to take action.
CONE
The kiln is in CONE FIRE MODE and needs the operator to input an appropriate Cone value from 022 to 10.
CPLt
The controller has completed a firing profile. The firing time in hours and minutes is displayed along with the
current internal temperature of the kiln. press ENTER to return to Idle Mode.
dELA
This is a prompt to enter a time in hours and minutes to delay the firing before starting the program. Enter a time
or all zeros for no delay.
E-##
A software error has occurred. Press any key to display the elapsed firing time and the temperature when the
error occurred. Consult section on Error Codes for troubleshooting information.
F1, F2, F3, F4, F5, F6, F7
Or
F8
The controller is in RAMP/HOLD mode. The user needs to input an end temperature in ° F or ° C for each segment
of the firing profile.
FAIL
The thermocouple and controller are not properly connected. Fix the connection, then Press ENTER to display the
kiln’s current temperature. Press Start after the connection is fixed. The thermocouple could be damaged. Check the
connections, if still no luck you may need a new thermocouple.
HOLd
Indicates a holding time in hours and minutes at the end of a CONE FIRE program.
HLd1, HLd2, HLd3, HLd4, HLd5, HLd6, HLd7 or HLd8
The controller is in RAMP/HOLD programming mode. The user needs to input a period of time in hours and
minutes that the controller should maintain for each segment of the firing profile.
-On-
Briefly displayed at the beginning of firing to indicate that the kiln has started.
PROG
A prompt at the beginning of a RAMP/HOLD program which allows the user to select a stored program.
a
PPendiCes