Uick, Tart, Cone fire mode – Skutt KilnMaster Kilns Manufactured after March 1 2006 User Manual
Page 7: The ramp/hold mode
7
Q
uiCk
s
taRt
Q
uick
s
tart
Quick Start is a memory aid, not a substitute to reading and understanding the manual.
Activate the power source by plugging in the kiln or controller. After plugging in the kiln, the display will read
WAIT for approximately 10 seconds while power is restored to the kiln. It will then switch to Idle Mode. In Idle
Mode the display will flash the kiln temperature alternating with
IdLE
.
On ZC models you will also see “TC2”
which indicates it is reading thermocouple 2.
Begin all programming in Idle Mode.
Be sure the programmer is set to the right temperature scale before proceeding (Fahrenheit or Celsius).
cOne Fire MODe
Step 1
Press
●
CONE FIRE
Step 2
Input
•
PREHEAT time.
Press ENTER
Step 3
Input Cone number.
●
Press ENTER
Step 4
Input a
●
SPEED
Press ENTER
Step 5
Input
●
HOLD time
Press ENTER
Step 6
Press
●
START.
THE RAMP/HOLD MODE
Step 1
Press
●
RAMP/HOLD.
Step 2
Input the
●
PROG Number
Press ENTER
Step 3
Input the number of segments
●
Press ENTER
Step 4
Input the first heating rate
●
Press ENTER
Step 5
Input the first temperature to reach.
●
Press ENTER
Step 6
Input
●
HOLD time.
Press ENTER
Step 7
Repeat steps 4 through 6
●
until alarm flashes
Press ENTER
Step 8
Press
•
START