Smart Avi 4K-Wall - Manual (Page 9)

USING RS-232 CONTROL
The 4K-Wall may also be controlled via RS-232 commands. This feature
requires an RS-232 card installed on your computer or a USB to RS-232
adapter. Below are instructions on how to properly create an RS-232 con-
nection between a PC the 4K-Wall
Establish a connection to 4K Establish a connection to 4K Establish a connection to 4K Establish a connection to 4K----Wall: Wall: Wall: Wall:
1. Connect a straight- through male-to- female RS-232 cable to the RS-
232 connector on the PC.
2. Connect the other end of the cable to the RS-232 port of the 4K-Wall.
3. Power on the device.
Setting up the Terminal Application:
Setting up the Terminal Application: Setting up the Terminal Application: Setting up the Terminal Application:
1. Run HyperTerminal on the PC (or use the terminal client of your
choice).
2. Select the correct COM Port on the PC.
3. Use the following settings to
create a connection to the
device: 115200
115200 115200 115200, 8 8 8 8, N N N N, 1 1 1 1.(see
settings on right).
4. Be sure that Flow Control is
None.
9