Swim'n Play Slim Style Oval Pool - Manual (Page 18)

18
Insert the 1/4" - 20x3/4" truss
head screws from inside the pool
through the preattached inside
closure bar, through inside and
outside wall ends, and through
outside closure bar.
The 1/4" serrated flange nuts are
secured to the screws on the outside
of the wall. All the holes must match
and be secured together with the
screws and nuts provided.
Tighten each screw and nut to 85
inch pounds of torque. If no torque
wrench is available, tighten each nut
until snug. Then tighten each nut
one (1/2) half additional turn. If nut
appears to be lose after tightening,
please check if the screw is stripped
or broken. It must be replaced.
Overtightening the nuts could cause the screws to fracture which could result in pool failure. Failure to tighten
the nuts sufficiently could also result in pool failure. This is one of the most important structural assembly aspects
you will perform. Be absolutely sure you have assembled the wall as shown above for your pool.
Manufacturer can not assume the responsibility of the performance of this product if the
instructions of closing the wall are not followed exactly.
Pool W
all
4 CLOSURE
BARS
1/4" x 20 x 3/4"
TRUSS HEAD
SCREW
INSIDE
OF POOL
1/4" x 20
SERRATED
FLANGE NUT
DANGER
YOU MUST ASSEMBLE THE POOL
WALL
AS PER INSTRUCTIONS
USE ALL THE 1/4"-20x3/4" TRUSS
HEAD SCREWS AND 1/4"-20
SERRATED FLANGE NUTS TO
CLOSE POOL WALL.
DO NOT LEAVE ANY OPEN HOLES
TIGHTEN EACH SCREW
TO 85 INCH POUNDS.
During this assembly procedure, make sure that
one washer is on the inside of the pool, and one
washer in on the outside of the pool sandwiching
the two wall ends between them. Also ensure that
the recesses of the walls and washers all face the
same direction. Align the holes in the wall ends.
From the inside of the pool, insert a
3/8 Truss Head screw through the
washer, through the holes on the
inside and outside wall ends, and
through the second washer.
Fasten with 3/8 serrated flange nut
on the outside of the pool having the
flange of the nut face the washer.
Only hand tighten the nuts at this
point. Continue for each hole in the
wall ends.
DO NOT LEAVE ANY OPEN HOLES.
Tighten all screws and nuts to 85
inch pounds. If no torque wrench is
available, tighten each nut until snug.
Then tighten each nut one half (1/2)
additional turn. If nut appears to be
lose after tightening, please check if
the screw is stripped or broken. If it is,
it must be replaced.
DANGER
YOU MUST ASSEMBLE THE
POOL WALL
AS PER INSTRUCTIONS
USE ALL THE 3/8-16x3/4"
TRUSS HEAD SCREWS,
WASHERS AND 3/8-16
SERRATED FLANGE NUTS
TO CLOSE POOL WALL.
DO NOT LEAVE ANY
OPEN HOLES
TIGHTEN EACH SCREW
TO 85 INCH POUNDS.
View from
the top
3/8" TRUSS
HEAD SCREW
WASHER
WASHER
3/8 FLANGE
NUT
Pool W
all
Pool W
all
Recessed
Posi-Lock System
During the manufacturing process, the
one end of the pool wall will have a
slight crease or bend in it. Straighten
out this bend as best as possible, and
assemble the pool wall putting this end
of the wall on the outside as shown.
INSIDE POOL
OUTSIDE
POOL
POOL WALL