Teac D-02 - Manual (Page 10)

10 10
Basic Operation
1 Turn the unit on.
When on, the ring around the POWER button and the display
light.
2 Press the INPUT button to select a source.
Each press of the button changes input and the selected source
appears on the display.
XLR1 DUAL XLR2 RCA1
RCA2 OPTICAL i.LINK USB
< When 2 XLR cables are connected and a Dual AES signal is being
received, choosing XLR1 causes only the left channel to be
output as a mono signal and choosing XLR2 causes only the right
channel to be output as a mono signal.
Play back the source after selecting it.
The text on the display flashes when a digital signal is
not detected. Turn on the connected device and check the
connections.
< The INPUT buttons (</>) on the remote control unit of the
optional P-02 can also be used to change the input.
3 Use the VOLUME (−/+) buttons to adjust the
volume.
When using an external amplifier to adjust the volume, set these
buttons “0.0” on this unit.
< The remote control unit of the optional P-02 can also be used for
VOLUME adjustment (–/+) and MUTING.
< Press the POWER button to turn off the unit after use.
Muting
If you press the MUTING button on the remote control included
with the optional P-02, you can temporarily mute the sound
output. Press again to restore the previous volume level.