Tecfluid MT03F - Manual (Page 29)

29
16 ASSOCIATED SOFTWARE WINSMETER MT03
Most of the steps in the preceding paragraphs can be done by means of the device
associated software Winsmeter MT03, which allows working in a more comfortable and
intuitive way.
Such software can be downloaded from the “Downloads” section of the Tecfluid S.A.
www.tecfluid.com/downloads
16.1 USB cable connection and drivers installation
Extract the files from the winsmeter MT03.zip to a new system folder.
Execute the Setup.exe file and follow the steps for the installation.
In order to connect the converter to a computer an USB cable is required. This cable is type
A at one end and type B at the other, and it is readily available on the market.
The ends of the cables can be seen in the picture.
The USB connector is located at the rear side of the converter.
Connect the USB cable at one end to the converter and at the other to the computer where
the software is installed.
Power on the electronic converter.