Tech Source Raptor DL-Lite Drivers for Linux - Manual (Page 12)

Raptor DL-Lite Drivers for Linux Installation & Reference Manual
3-2
The software has been fully tested under Red Hat 7.3, Red Hat
8.0, Red Hat 9.0, Red Hat Enterprise Linux (x86 and x86_64)
and SuSE 8.2. Updating or recompiling the kernel or the
XFree86 distribution may cause the driver and DDX to fail to
load. In this case, please contact our technical support team for
a possible solution (See Chapter 6). The software consists of
the following modules:
rapdlt.o
UP Kernel driver
rapdlt_smp.o
SMP Kernel driver
rapdlt_drv.o
XFree86 DDX module
libMOX.a
MOX extension module
3.3 CD-ROM Installation
The following are step by step instructions for installing the
Raptor DL-Lite Drivers for Linux from a CD-ROM.
1. Login as
root
on the target system, using
/bin/sh
as
your shell.
2. Insert the CD-ROM labeled “Raptor DL-Lite Drivers for
Linux” into the drive.
3. If the drive is already mounted, type:
prompt# cd /mnt/cdrom/linux/
4. If the CD-ROM is not already mounted, type:
NOTE: Rebooting the system after the Raptor card installation
may cause the auto configuration manager to come up in
some distributions. At this point, ignore the auto configuration.
Refer to Section 3.6 to configure the Raptor card after the
software is installed.