Tech Source Raptor Drivers for Linux - Manual (Page 30)

Raptor Drivers for Linux Installation and Reference Manual
4-8
Option
This boolean field is useful when monitors of
“ScaleCursPos”: different screen sizes are used together in a
multi-screen configuration. When the cursor
crosses screen boundaries, its position on
the new screen will be adjusted to be
proportional to where it was on the previous
screen.
Option This field is only used while in 8+8 mode. It
"TranspColor": allows the user to specify the RGB color
values associated with the transparent color
of the overlay. If an application is
mistakenly using the transparent color, the
value of the color can be changed so that
the application no longer uses it. The
default value is
0x0A3246
.
If more than one Raptor card is installed, another
Device
section needs to be created with unique entries in the
Identifier
,
BusID
and
Device
Option fields that
correspond to this additional card. For more information
please refer to Section 5.5.
4.6.3 Screen Section
Identifier: Each screen must have a unique identifier
which will be used in the
ServerLayout
section.
Device: This field specifies which device you want to
use for this screen. It should match the
Identifier specified in one of the
Device
sections.