Teletronics WL11000SA-N - Manual (Page 8)

User’s manual – WL11000SA-N
8
Configuration
The diskette labeled “Utility Diskette”, that comes with the package contains a utility program
for the WL11000SA-N Wireless Access Point. Any updates can be downloaded from
Teletronics International Inc web site at:
http://www.teletronics.com.
Warning: Backup your utility diskette and use the copy as the working diskette to
protect the original from accidental damage.
The WL11000SA-N can be configured over an Ethernet network using RJ-45 cable or wireless
device that link to this AP. You may connect the WL11000SA-N to a network device such as a
hub or switch. Then, run the utility program, and configure the WL11000SA-N remotely as
described below.
Windows NT/95/98/ME/2000 Installation
1. Insert the WL11000SA-N utility disk into the floppy drive on your PC, and then enter the
following command: A:\utility\setup.exe. Follow the on-screen instructions to install the
utility program.
2. When you run the installed utility click on “AP” and then select “Scan” from the menu, the
program will then detect all the WL11000SA-Ns wired to the Ethernet network