Thinklogical VDA Manual - Manual (Page 11)

V D A S e r i e s D V I S p l i t t e r s , R e v . C , M a y , 2 0 1 4 Page 8
VDA-3:
1. Connect a Dual-Link DVI-D male to male cable from your DVI Monitor 1 to the DVI
OUT 1 DDC connector on the VDA Splitter’s front panel. Connect a Dual-Link DVI-D
male to male cable from your Output Monitor 2 to the DVI 2 connector. Turn the
monitors on.
2. Connect the supplied Dual-Link DVI-D male to male cable to the video source (DVI-D
video card) and to the DVI IN DUAL-LINK connector on the VDA Splitter.
3. Connect the 5VDC Power Supply (PWR-000022-R) to the INPUT POWER JACK
located on the front panel of the VDA Splitter’s chassis and plug it into a standard AC
source. (May not be required with some video cards.) Ensure all video output displays
are functioning properly.