Venstar T1100REC - Manual (Page 16)

STEP #5 TEST OPERATION
Press the MODE button repeatedly until
the HEAT icon appears on the display.
Press the UP or DOWN button until the set
temperature is 10 degrees above room
temperature. The HVAC unit should
energize in the heating mode.
Press the MODE button repeatedly until
the COOL icon appears on the display.
Press the UP or DOWN button until the set
temperature is 10 degrees below room
temperature. The HVAC unit should
Turn the power on to the Heating/Air
Conditioning system.
energize in the cooling mode.
Press the UP button until the setpoint is
equal to the room temperature. Press the
FAN button to Fan On. The fan should turn
on and run continuously.
NOTE: Most equipment has a time delay
of 5 minutes between cooling cycles. This
feature is defeatable on the thermostat
(see page 13, step 8 of the Thermostat
Manual).
HEAT
COOL
FAN
POWER
HEAT
COOL
FAN
POWER
HEAT
COOL
FAN
POWER
HEAT
COOL
FAN
POWER
Page 15
HEAT
COOL
FAN
POWER
HEAT
COOL
FAN
POWER
HEAT
COOL
FAN
POWER
HEAT
COOL
FAN
POWER