Verilink AS4000 (34-00244) Product Manual - Manual (Page 5)

Verilink AS4000 User Manual v
Canadian Requirements This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of
Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques (de la class A) prescrites dans le Règlement sur le
brouillage radioélectrique édicté par le ministère des Communications du Canada.
The Industry Canada label indentifies CS-03 certified equipment. This certification means that
the equipment meets certain telecommunications network protective, operational and safety
requirements. Industry Canada does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to
the facilities of the local telecommunications company. The equipment must also be installed
using an acceptable method of connection. In some cases, the company’s inside wiring
associated with a single line individual service may be extended by means of a certified
connector assembly (telephone extension cord). The customer should be aware that compliance
with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request the user
to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe system, if present, are connected
together. This precaution may be particularly important in rural areas.
CAUTION
Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.
Safety Precautions This equipment is intended to be installed only in a Restricted Access Location that meets the
following criteria:
• Access can only be gained by service personnel or users who have been instructed about
the reasons for the restrictions applied to the location and about any precautions that
must be taken.
• Access can only be gained through the use of a lock and key or other means of security,
and is controlled by the authority responsible for the location.
When handling this equipment, follow these basic safety precautions to reduce the risk of
electric shock and injury:
• Follow all warnings and instructions marked on the product and in the manual.
• Unplug the hardware from the wall outlet before cleaning. Do not use liquid cleaners or
aerosol cleaners. Use a cloth slightly dampened with water.
• Do not place this product on an unstable cart, stand, or table. It may fall, causing serious
damage to the product.
• Slots and openings in the shelves are provided for ventilation to protect them from
overheating. These openings must not be blocked or covered. Never place this product
near a radiator or heat register.
• This product should be operated only from the type of power source indicated on the
marking label and manual. If you are unsure of the type of power supply you are using,
consult your dealer or local power company.
• Do not allow anything to rest on the power cord. Do not locate this product where the
cord will interfere with the free movement of people.
• Do not overload wall outlets and extension cords, as this can result in fire or electric
shock.