Westermo RM-505U-2-E - Manual (Page 35)

User Manual
MAN_505_1.7.DOC Page 35
The setpoint values may be
set between 0 and 100%
corresponding to 0mA and
20mA. The low setpoint
may be set to the same value
as the high setpoint,
however the low setpoint
should not be set to a higher
value than the high setpoint.
4.6 Pulse Inputs
There are several configurable parameters for pulse inputs. The debounce value can be adjusted
from the Unit Details selection, as per Digital Inputs.
If either pulse input has an input rate of more than 10Hz, then the Fast Pulse Input option should be
selected from the Pulsed Inputs selection.
If the pulse inputs
are connected to a
shaft encoder
(incremental or
quadrature types),
then the Shaft
Encoder Inputs
option should be
selected.
The pulse inputs
also have a Sensitivity value. The pulse input sensitivity is the number of pulse increments since the
last transmission to trigger another transmission. For example, if the pulse count at the last
transmission for a pulse input was 1000, and the sensitivity value is 10, then another transmission
will occur when the pulse count
reaches 1010 (provided there has
not been an update transmission
during this period). The
sensitivity values can be between
1 and 32000.