Using multiple pmon-1001 in same area – ACTi PMON-1001 User Manual
Page 18
PMON-1001 Product Manual
Using Multiple PMON-1001 in Same Area
For large scale installations there may be a need for more than 1 unit of PMON-1001. Having
two or more PMON-1001 within the same area would require a clear distinction between each
wireless network naming so that the Apple mobile device could connect to the right network.
It is possible to change the ID and password of the wireless network of PMON-1001 in its
firmware. For example, you can name the PMON-1001 networks as
“Camera_Helper1”,
“Camera_Helper2”, etc.
To access the firmware of PMON-1001, you need to connect an Ethernet cable from your PC
to the Ethernet port of PMON-1001. Since the default IP of PMON-1001 will be 192.168.0.1
and mask 255.255.255.0, therefore you need to make sure that the IP settings of your PC are
within the same network segment.
Adjusting the IP address of the PC
In the TCP/IP settings of your PC, set an IP
address as 192.168.0.xxx, where xxx is any
number between 2 and 254. The subnet
mask is to be 255.255.255.0.
Connecting to the firmware via web browser
Open the web browser and key in the IP address of PMON-1001.