Alinco DJ-A11E - Manual (Page 21)

Professional
FM Transceiver 4
Even if you do not use the battery pack for a long time, charge it at least once every three ▼
months to prevent deterioration.
How to Charge
Plug the AC adaptor into the AC outlet, and then plug the 1.
cable of the AC adaptor into the DC jack located on the
back of the Charger. The Indicator lights orange (1s) and
then goes out----waits to charge.
Plug the battery or transceiver into the charger. Make 2.
sure that the battery terminals are in contact with
charging terminals well. The Indicator turns into twinkling
red-----Pre-charging begins.
After pre-charging for about 5 minutes, the 3. indicator will
stop twinkling----charging begins.
It takes approximately 4 hours to fully charge the battery. When the lamp lights green, the charging 4.
is finished. Remove the battery or the transceiver equipped with battery from the stand.
BATTERY INFORMATION
NOTE: when charging a power-on transceiver equipped with battery, the indicating lamp will not
turn into green to show the fully charged status.Only when the transceiver is switched off, can the
lamp indicate normally. The transceiver consumes energy when it is power-on, and the charger can
not detect the voltage when the battery has been fully charged. So the charger will charge battery in
constant voltage and fail to indicate correctly whether the battery has been charged fully.
Ac Input