Parameter setting mode, Frequency step setup, Dtmf, dtmf ani, 2tone or 5tone signaling – Alinco DR-138 User Manual
Page 24
16
Press
2.
/
key to choose No.01 menu, LCD displays "STP--
125".
Turn
3.
Main Dial to select the desired frequency channel step.
Available steps in KHz are: 2.5(shown as 2K5), 6.25(62), 8.33(83),
10, 12.5(125), 20, 25, 30 and 50.
Press
4.
key to confirm and exit
Press and hold
1.
key for over 2
seconds to enter setting menu.
Press and hold
1.
key for over 2 seconds to enter the parameter
setting mode.
Press
2.
or
to select the desired menu.
Turn
3.
Main Dial to select the desired parameter.
Press
4.
to confirm and exit.
Only in VFO mode, this function is valid. Turn Main Dial to select
frequency step.
7
PARAMETER SETTING MODE
Frequency Step Setup
This function is not available in memory-mode.
DTMF, DTMF ANI, 2Tone or 5Tone Signaling
DTMF/5Tone/2Tone signalling are used for selective-calling. DTMF
and 5Tone signalling can be applied for other advanced features such
as ANI, PTT ID, group call, remotely stun, remotely kill, waken,...etc.
The signalling edition must be done in advanse to operatins through
programming software.
Press and hold
1.
key for over 2
seconds to enter into setting menu.
Press
2.
/
to choose No 2 menu,
LCD displays "
T-OFF" .
Turn Main Dial to
3.
select the desired setup.
"DTMF”: The channel will be mute by a DTMF signal. The
speaker won’t sound until receiving a correspondent DTMF
signal. Hold "PTT" then press [UP] directly to transmit the pre-
stored DTMF tones.
In DTMF signaling mode, press
for 2 seconds until LCD
displays "AN---", turn Main Dial to select desired digit(the other
party ID). In this mode, press
to confirm exist digit and move
cursor to next, press
to forward cursor. After editing, press
key to operate ANI call.
"2TONE": The channel will be mute
by a 2-Tone signal. The speaker won’t
sound until receiving a correspondent
2-Tone signal. Hold [
PTT] then press
[
UP] to transmit the pre-stored 2-Tone
signal.
"5Tone": The channel will be mute by
a 5-Tone signal. The Speaker won’t
sound until receiving a correspondent 5-Tone signal. Hold [
PTT]
then press [
UP] directly to transmit the pre-stored 5-Tone signal.
IMPORTANT: All or a part of operation in this chapter may not be
available to dealer-programmed units.
The default setting list is available on P29.