All Power AP-SB055E - Manual (Page 10)

WARNING: Read Owner’s Manual before operating machine. Never direct discharge toward
bystanders. Stop the engine before unclogging discharge chute or auger housing and before leaving
the machine.
TO STOP YOUR SNOW THROWER
1. To stop throwing snow, release the
auger drive lever. See Figure 6.
NOTE: If the snow thrower continues to slowly move forward, see “How To Adjust The Auger Control Cable” in
the Service And Adjustment Section.
2. To stop the engine, move the ignition switch key to the off position (Red Mark) .
9
KNOW YOUR SNOW THROWER
READ THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the
illustrations with your SNOW THROWER to familiarize yourself with the location of various controls and adjustments.
Save this manual for future reference.
ENGINE AND SNOW THROWER OPERATING CONTROLS
The engine operating controls and their functions are as follows:
Auger Drive Lever - Starts and stops the auger.
Crank Assembly - Changes the direction of snow throwing through the discharge chute.
Chute Deflector - Changes the distance the snow is thrown.
Discharge Chute - Changes the direction the snow is thrown.
Ignition Switch Key - Must be inserted and turned to the ON position to start the engine.
Recoil Starter Handle - Starts the engine manually.
Electric Starter Button - Use to start the engine when using the 120V electric starter.
Choke Control - Used to start a cold engine.
Primer Button - Injects fuel directly into the carburetor manifold for fast starts in cold weather.
Spark Plug Access Panel - Aides in the removal of the spark plug.
Oil Fill Cap/Dipstick Access Panel - Allows access to oil fill cap/dipstick for both filling and checking the engine oil
Switch Box - Connection for the electric start power cord.