All Power AP-SB055E - Manual (Page 9)

Adjust The Upper Chute
1. Remove the T--knob and bolt on the
upper chute (Figure 4).
2. Rotate the upper chute to the operating
position (past the lower chute stop).
3. Install the bolt and tighten the T--knob.
Add Engine Oil
1. The snow thrower was shipped with a container of 5W30 engine oil. Before operating, add this oil to the
engine .
2. Remove the oil fill cap/dipstick access panel.
3. Remove the oil fill cap/dipstick (Figure 5). Fill to the FULL mark on the oil fill cap/dipstick. Periodically
check the oil level. DO NOT OVER FILL.
Add Fuel
1. Fill the fuel tank with fresh unleaded fuel.
2. To extend the life of the fuel and prevent
starting problems, add the fuel stabilizer
supplied with the snowthrower.
DO NOT OVER FILL.
CHECKLIST
Before you operate your new snow thrower, to ensure that you receive the best performance and
satisfaction from this quality product, please review the
following checklist:
1. All assembly instructions have been completed.
2. The discharge chute rotates freely.
3. No remaining loose parts in carton.
While learning how to use your snow thrower, pay extra attention to the following
important items:
1. Make sure engine oil is at proper level. Use a high quality detergent oil classified “For Service SG, SH, SJ,
SL, or higher”.
2. Make sure the fuel tank is filled properly with clean, fresh, unleaded gasoline with a minimum of 85 octane.
3. Become familiar with the location of all controls and understand their function.
4. Before starting the engine, make sure all controls operate correctly.
8