All Power AP-SB055E - Manual (Page 17)

CUSTOMER RESPONSIBILITIES
GENERAL RECOMMENDATIONS
The warranty on this snow thrower does not cover items that have been subjected to operator abuse or
negligence. To receive full value from the warranty, the operator must maintain the snow thrower as instructed
in this manual.
EMISSIONS CONTROL
Maintenance, replacement, or repair of the emission control devices and systems can be performed by any
non-road engine repair establishment or individual. However to obtain a “no--charge” emissions control service,
the work must be done by a factory authorized dealer. See the Emissions Warranty.
WARNING: Do not strike the flywheel with a hammer or a hard object. If done, the flywheel can
shatter during operation. Do not tamper with the governor spring, links or other parts to increase
engine speed.
AFTER EACH USE
1. Run the machine to clear the auger of snow.
2. To prevent freezing of the auger or controls, remove all
snow and slush from the snow thrower.
3. Check for any loose or damaged parts.
4. Tighten any loose fasteners.
5. Check and maintain the auger.
6. Check controls to make sure they are functioning properly.
7. If any parts are worn or damaged, replace immediately.
LUBRICATION BEFORE STORAGE
16