All Power AP-SB055E - Manual (Page 8)

References to the right or left hand side of the snow thrower are from the viewpoint of the operator’s position
behind the unit.
HOW TO REMOVE FROM THE CARTON
1. Locate and remove container of 5W30 oil.
2. Locate all parts packed separately and remove from the carton.
3. Remove and discard the packing material from around the snow thrower.
4. Cut down all four corners of the carton and lay the panels flat.
5. Hold onto the lower handle and pull the snow thrower off the carton.
CAUTION: DO NOT back over cables.
6. Remove the packing material from the handle assembly.
HOW TO ASSEMBLE THE HANDLE
Install Upper Handle
1. Remove the knobs and U—bolts from the lower handle (Figure 2).
2. Put the upper handle in the operating position.
3. Install the U--bolts and tighten the knobs.
Note: Make sure that the cable is not pinched between the upper and lower handle. Make sure the cable
is routed as shown in Figure 2.
Figure2
Attach Auger Drive Cable
1. Attach the auger drive cable to the auger drive lever using the Z-hook (Figure 3).
7
WARNING: Always wear safety glasses or eye shieldswhile assembling snow thrower.
TOOLS REQUIRED
1 -- Knife to cut carton
Figure 1 shows the snow thrower in the operating position.