Allmand Brothers TLB6235 Tractor - Manual (Page 2)

2
INSPECTION CHECK LIST
FOR PREPARING TLB 6235 FOR DELIVERY OR RENTAL
The TLB 6235 requires service as well as proper operation in order to provide the perfor-
mance and safety it has been designed for. Never deliver or put a machine into service with
known defects or missing instructions or decals. Always instruct the customer in the proper
operation and safety procedures as described in the operator’s manual. Always provide the
manual with the equipment for proper and safe operation.
CHECK LIST:
Visually inspect the equipment to ensure that all instructions and decals are in place and
legible.
Inspect the hydraulic system to insure all connections are tight and secure.
Lubricate all grease fittings with recommended grease.
Inspect all hydraulic hose for proper routing and signs of damage.
Check the condition of the hydraulic cylinders.
Inspect the steering system, tie rod ends, spindles and wheel bearings and tighten rod
ends regularly.
Check the outriggers and make sure they operate properly.
Tighten lug nuts to 80 ft/lb every 50 hours of operation.
Inspect the loader and backhoe for damage and test for proper operation.
Inspect the loader bucket stops for damage. (there should be at least 1/2" clearance be-
tween cylinder rod and bucket pin grease zerk).
Inspect the electrical wiring for signs of damage.
Inspect the park brake for proper holding strength.
Inspect the tires to ensure good condition and proper inflation.
Make sure the battery is fully charged and terminals are tight and clean. Insure the electro-
lyte is at the correct level.
Check the service intervals for oil filters, fuel filter, air cleaner, engine oil and hydraulic oil.
Check the engine oil, hydraulic oil and fuel levels.
Start engine and check for hydraulic leaks.
Check to make sure the operator’s manual is with the equipment.
Inspect the machine physically for damage and repair if necessary.
NOTE: See appropriate section of manual for scheduled maintenance intervals
After completing the inspection checklist, operate the loader and backhoe through a com-
plete operation cycle, following the operating instructions in the operator’s manual.
NEVER ALLOW ANYONE TO OPERATE
THE EQUIPMENT WITHOUT PROPER TRAINING!
ALWAYS READ THE INSTRUCTIONS FIRST!
WARNING