Allmand Brothers TLB6235 Tractor - Manual (Page 27)

27
WARNING: Accidental Starts!
Before servicing the engine or equipment, always remove the ignition keys to insure there will not be any accidental start up. Make
sure the equipment is in neutral and park brake set.
MAINTENANCE SCHEDULE
These required maintenance procedures should be performed at the frequency stated in the table. They should also be included as
part of any seasonal tune-up.
NOTE: Every 500 hours of operation, separate the pump from the engine. Clean the splined areas and lightly grease
the male portion of the pump spline. Use either Dow Corning G-N Metal Assembly Paste or #77 Assembly Paste.
When remounting the pump, be certain the mating surfaces are clean and correctly aligned.
MAINTENANCE INSTRUCTIONS
MAINTENANCE
O - Indicates that jobs must be done after the first 5 hours respectively.
* - Perform these maintenance procedures more frequently under extremely dusty and
dirty working conditions.
Hydraulic fluid should be changed every 1000 hours after the first 250 hour change.
NOTE: All daily checks should be done with every engine oil change.
NOTE: Change hydraulic return filter at the first 50 hours then every 200 hours.
!
HOURLY INTERVALS
NO. CHECKPOINTS 8 50 200 250 500 750 1000
1 Check engine oil level, fill if needed X
2 Change engine oil with seasonal viscosity X X X X X
3 Cooling system circuit cleaning X
4 Check battery electrolyte level X X
5 Replace oil filter cartridge X X X
6 Check fan belt for tightness X X X
7 Check oil cooler fins, clean as necessary X X X
8 Check fuel tank for sediment, clean as necessary X X
9 Check radiator hoses and clamps for leaks X X
10 Starter and alternator check X
11 Check fuel lines for leaks X
12 Check air cleaner element X X
13 Replace air cleaner element X
14 Check electrical wiring for damaged or loose connections X X X
15 Tighten tie rods to 35 ft/lbs. X X X X X X
16 Tighten lug nuts to 80 ft/lbs. X X X X X X
17 Check hydraulic oil level, fill if necessary X X
18 Check all fasteners for tightness X X
19 Check backhoe bucket teeth, replace if necessary X
20 Grease all swivel points (loader and backhoe) X
21 Clean or replace suction strainers X X
22 Grease right foot pedal mount and center bearing mount X
23 Check fuel filter, replace if necessary X
24 Check hydraulic hoses for damage and loose connections X X X X
25 Change hydraulic return filter X X X
26 Change hydraulic fluid X X
27 Check loader bucket stops for damage X