Allmand Brothers TLB6235 Tractor - Manual (Page 42)

42
SA/HR Park Brake Testing Instructions
1. Mount tractor on Jack Stands to allow the
wheels to spin freely (See Figure 75).
2. Start the Engine. Make sure that all 4
wheels rotate in forward and reverse.
3. Turn off the engine.
4. Unhook the quick coupler from the brake
that was previously installed (See Figure
76).
5. Start the Engine.
6. Actuate the pedal.
7. Make sure that all 4 wheels do NOT rotate
in forward or reverse. If the wheels rotate
then refer to the installation instructions.
8. Turn off the engine.
9. Reinstall the quick coupler. This will
complete the TLB 6235 SA/HR Park Brake
Installation. Your Allmand TLB is now ready
to be put back into service.
SA/HR Park Brake Towing Instructions
1. Disconnect the quick coupler from the
brake (See Figure 76).
2. Reconnect the brake to a hydraulic hand
pump (See Figure 77).
3. Pump the hydraulic hand pump to ap-
proximately 200 psi.
4. Start tractor. Make sure the wheels rotate
freely, if they do then the tractor is ready for
towing.
FIG. 76
FIG. 75
FIG. 77