ARAG BRAVO 300S - Multi-row crop sprayers, Direct connection / RCU Installation - Software ver - Manual (Page 10)

10
6.2 Monitor and control unit positioning
The BRAVO 300S series computer must be placed in the control cabin of the farming machine.
Observe the following precautions:
- Do NOT install the monitor in areas where it would be subjected to excessive
vibrations or shocks, to prevent any damage or accidental use of the control keys;
- Install the device in a visible position within easy reach by hand; bear in mind that
the computer should not obstruct the operator’s freedom of movement or block his
view.
• Control unit (RCU): secure the control unit on the back of the machine, close to the control unit
and the hydraulic unit.
Consider all necessary connections of the computer, the cable length, and make
sure there is enough space for connectors and cables.
An identification symbol is located next to each connector to indicate its function.
For any reference to the system configuration read Par. 6.1 - System recommended
composition.
Fig. 4a
item Monitor connection points
1 Control unit and sensors
2a Power supply
2b
Monitor power supply +
RCU connection
3 Auxiliary connections
4 SD memory card
Fig. 4b
item rcu connection points
5 Monitor
6 Power supply and sensors
7 Control unit
8 Hydraulic unit
CONTINueS
Tab. 1
Tab. 2