Archgard 40-DVI40N - Manual (Page 26)

Optima 40 - SB
26
GLASS DOOR REMOVAL
1. Remove the TOP louver by pulling the entire louver assembly towards you.
2. Open up the BOTTOM louver assembly to expose the control valve by removing the
dashboard. (See Fig. 1 below) Be careful not to pull wire leads too far. Doing so could
cause parts or components to dislodge from the fireplace.
3. Locate the 3 buckle latches under the glass door frame and pull down the lever on the back
of the latches to release them.
4. Unhook the latches from the bottom of the door and swing the bottom of the door towards
you then lift up on the whole door to unhook the top of the door. Carefully remove the door
and put it away at a safe location where it cannot be scratched or damaged.
Replacing the Glass Door
The reverse procedure of Removing the Glass Door.
IF YOUR GLASS BREAKS
WARNING: Do not substitute glass components with other material types. Do not
abuse the glass doors such as striking or slamming shut. Do not use abrasive glass
cleaners. Do not clean the glass when hot. Do not operate this appliance with broken
glass. Do not attempt to remove the glass door when the appliance is hot.
In the event your glass cracks or breaks, Archgard recommends that a new door assembly be
ordered to replace the original door.
 Remove door as per the instructions above.
 Replace with new door assembly
NOTE: The NEW door will emit some odor when the appliance is re-lit and the odor will
dissipate after the gasket material within the door has cured.
WARNING: Do not operate appliance with the glass front removed, cracked or broken.
Replacement of the glass should be done by a licensed or qualified service person.