ARM Electronics JHD - Manual (Page 6)

JPEG2000 Stand alone DVR User Guide
- 6 -
1-1 Front panel introduction
1.[CD-RW]
Built-in CD-RW for CD back-up.
2.[USB Port]
DEVICE:Connect PC for firmware upgrade.
HOST: Connect USB memory stick for backup.
3.[IR Receiver & LED Lamps]
IR Remote Controller Receiver.
DVR Status LED:
RUN- Flashes when play picture by picture through J. Shuttle.
ACTIVE- On when the J. Shuttle is ready to use.
REC- On while recording and flashes at stand-by mode, such as no motion triggered at the motion record mode
PLAY- On while playback.
FULL- On when HDD storage is full.
NET- On when the DVR is connected remotely.
4.[1~16 Channel Button]
Switch full screen among channels, 1 for Channel 1, 2 for Channel 2, and so on.
5.[MODE]
Switch among full and split screen displays.
6.[K.LOCK]
Lock the buttons on front panel.
7.[MENU]
Enter the menu and set up.
8.[Directions & ENTER]
Directions- Navigate the menu.
ENTER- Confirm the selected options.
9.[Jog Shuttle]
In playback: inner rim to play picture by picture, outer rim to play fast forward and backward. Turn clockwise to
play fast forward, and counterclockwise to play fast backward.
Turn the Jog Shuttle to change values in system set-up.
CHAP.1 Appearance