ARM Electronics Casino VCR800 - Manual (Page 18)

ALARM RECORDING ( CONTINUED )
English-18
You must set the alarm recording mode in the RECORD MODE SET UP menu before executing
alarm recording.
When you finish ALARM RECORDING SETUP by following 1~3 steps above, try inputting the
alarm signal. Then recording will start with buzzer. If you set the DURATION to T-END,
recording will be done to the end of the tape. If you set it to 30 SEC(or 1, 5, 10 MIN), recording
will be done within the indicated time.
LEVEL setup - The recording continues for 30 SEC. in case of within 30 SEC.
- The recording continues for the time that ALARM IN signal is input in case of
above 30 SEC.
During alarm recording, the alarm recording mark (’A’) will automatically be displayed on
screen.
* The alarm in indicator(ALM) blinks during alarm recording and on when the alarm
recording is finished.
* When the alarm recording is finished, the VCR resumes recording in the same record
modes as before the alarm recording.
Press the MENU button to display MENU on the monitor.
Then Select RECORD MODE SET UP using MOVE button. 1
Set Speed NTSC : (L8H, L24H, L40H)
Set Speed PAL : (L3H, L15H, L27H) 2
* If a set signal is applied during alarm
recording, a new alarm recording will
start with the new set signal.
* Alarm recording will continue for the
duration of time which has been set in
ALARM REC DURATION menu, even if
a timer recording has reached its end
time.
* Alarm recording stops when the end of
the tape is reached.
* Alarm recording can start recording
when an alarm is triggered even if the
VCR is stopped or is set for timer
recording.
NOTE
[ MENU ]
LANGUAGE ENGLISH
CLOCK SET UP
▶ RECORD MODE SET UP
SYSTEM SET UP
TIMER RECORD SET UP
SEARCH SET UP
OTHERS
[ ▼ ] [ ▶ ] [MENU] END
[ RECORD MODE SET UP ]
▶ ALARM REC MODE L8H
ALARM REC TIME 30SEC
1SHOT REC 1SEC
VEXT OUT 1FIELD
SERIES REC OFF
REPEAT : OFF
REWIND/STOP
[ ▼ ] [ ▶ ] [MENU] END
Set 30Sec(1/3/5 MIN/T-END/LEVEL) 3