Eneo HDD-2030PTZ1080 - Manual (Page 15)

3.4 Auto Scan (Shortcut: SCAN)
The Auto Scan supports up to 17 programmed angles at user-programmable speeds.
Follow these steps to program Auto Scan:
AUTO SCAN SETUP
NUMBER : 01
TITLE : A01
MODE : NORMAL
SPEED : 5 STEP
START ANGLE : ----- -----
END ANGLE : ----- -----
SCAN DIR : CCW
SWAP : OFF
DWELL : 03 SEC
SAVE AND EXIT(ESC TO CANCEL)
NUMBER 01 ~ 08, 10 ~ 17, 09: AUTO-PAN mode.
TITLE
up to 6 characters
MODE NORMAL, VECTOR, RANDOM (AUTO-PAN mode: NORMAL, RANDOM only).
NORMAL Move from start point to end point in panning only
VECTOR Move from start point to end point including tilt and zoom simultaneously
and linearly.
RANDOM Move randomly between the start point and the end point
SPEED 1 ~ 13 step, the lower number means the slower speed.
SCAN DIR Set the Scan direction, CCW (Counter Clock Wise), CW (Clock Wise).
SWAP
Swaps the start point for the end point.
DWELL Set the dwell time at the both end, 01 ~ 99 seconds.
1. Press the SCAN key to enter the Auto Scan menu directly. Or press the MENU key to display
the main menu on the monitor. Scroll to Auto Scan and push the Joystick to the right.
2. Select “NUMBER” and set the desired number by pushing the Joystick to the left or right.
3. Select “TITLE” and twist the Joystick to enter the title edit mode.
4. Twist the Joystick to change the alphanumeric characters and move the next position by
pushing the Joystick to the left or right. Or move down to the character table and press the
CTRL or IRIS Open key at the desired character then the cursor position moves to the next
position automatically. Push the Joystick to the left or right at the “ALL DELETE” field to delete
all characters. Push the Joystick to the left or right at the “EXIT” field to finish title edit menu.
TITLE EDIT MENU
(CTRL KEY)
A01
*
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 ( )
ALL DELETE
EXIT(ESC TO EXIT)
5. Select “MODE” and “SPEED”.
10