Eneo HDD-2030PTZ1080 - Manual (Page 18)

Select “AE SETUP” and push the Joystick to the left or right. Then the AE setup displays.
Refer to the AE SETUP in the camera setup.
6. Set “DWELL time”. (03 ~ 99 seconds)
7. To select the next page of Presets, scroll the page by pushing the Joystick to the left or right on
the first or last columns of the menu.
8. Repeat step 2 through 7 for each additional Preset position.
9. Select “SAVE AND EXIT” and push the Joystick to the right or press the IRIS Open key. Press
the ESC or IRIS Close key to exit the program without saving.
NOTE: Press the HOME key at programmed Preset position ( *) to delete a programmed
Preset view.
The position, which is marked with the *, already has the Preset view assigned. Press the PRST
key on the * to review the stored Preset. The camera will show the stored Preset scene.
PRESET AREA SETUP
(CTRL KEY)
NUMBER 001
PAN TILT
000.0 000.0
EXIT(ESC TO EXIT)
Hold down the CTRL key while selecting the desired scene using the Joystick. Current position
will be displayed. Release the CTRL key to complete. Or press the IRIS Open key then the
“CONTROL” displays. Move the desired position and the zoom position. Press the IRIS Close key
then the “CONTROL” disappears. Select “EXIT” and push the Joystick to the right.
3.6 Shortcut of Preset Program
After selecting the desired scene, press No. (1 to 240), and press the CTRL and PRST keys
subsequently. The current view will be stored to the selected Preset number if the Preset number
is empty. If selected Preset number is not empty, “OVER WRITE” message will be displayed on
the monitor and select the “OK” and push the Joystick to the right to overwrite.
Example: 1 , 0 , 1 + CTRL + PRST keys will store current view as Preset no. 101. In this case,
focus will be programmed as Auto, dwell time will be set to 3 second, and the current
AE mode will be programmed.
13