H3C Technologies H3C MSR 50 - Manual (Page 18)

1-17
Configuring Auto AP
The auto AP feature allows an AP to automatically connect to an AC. When you deploy a wireless
network with many APs, the auto AP function avoids configuration of many AP serial IDs, thus
simplifying configuration.
Follow these steps to configure auto AP:
To do… Use the command… Remarks
Enter system view system-view —
Enable the auto-AP function wlan auto-ap enable
Optional
Enabled by default.
Enter AP template view
wlan ap ap-name model
model-name
The model number of the AP is
specified only if an AP template
is created
Set auto-AP serial ID serial-id auto Required
Exit AP template view quit —
Convert auto AP into
configured AP
wlan auto-ap persistent
{ name auto-ap-name
[ new-ap-name ] | all }
Optional
Configuring CAPWAP Dual-Link (Supported only on ACs)
Follow these steps to configure CAPWAP dual-link:
To do… Use the command… Remarks
Enter system view system-view —
Specify the address of the
backup AC wlan backup-ac { ip ipv4-address |
ipv6 ipv6-address }
Required.
By default, no backup AC
address exists.
Enter AP template view wlan ap ap-name model model-name
The model number needs to
be specified only during new
AP template creation.
Specify the AP connection
priority for the AC
priority level priority
Optional
By default, the AP connection
priority of the AC is 4.
If an AC has an AP
connection priority of 7, the
AC becomes the primary AC.
When the primary AC fails
and then recovers, it will
re-establish connections with
APs and become the master
AP.