H3C Technologies H3C MSR 50 - Manual (Page 31)

1-30
n Figure 1-20 802.11n configuratio
Configuration procedure
# Configure a WLAN-ESS interface.
<AC> system-view
[AC] interface wlan-ess 1
[AC-WLAN-ESS1] quit
# Configure a service template and bind the WLAN-ESS interface with the service template.
[AC] wlan service-template 1 clear
[AC-wlan-st-1] ssid abc
[AC-wlan-st-1] bind WLAN-ESS 1
[AC-wlan-st-1] authentication-method open-system
[AC-wlan-st-1] service-template enable
[AC-wlan-st-1] quit
# Configure the AP on the AC.
[AC] wlan ap ap1 model WA2610E-AGN
[AC-wlan-ap-ap1] serial-id 210235A29G007C000020
# Configure the radio of the AP to operate in 802.11g/n mode.
[AC-wlan-ap-ap1] radio 1 type dot11gn
# Configure the working bandwidth of the radio as 40MHz.
[AC-wlan-ap-ap1-radio-1] channel band-width 40
[AC-wlan-ap-ap1-radio-1] service-template 1
[AC-wlan-ap-ap1-radio-1] radio enable
WLAN Service Configuration Example (on a FAT AP)
Network requirements
z As shown below, a fat AP is connected to a Layer 2 switch. The IP address of the fat AP is
10.18.1.10.
z It is required to configure WLAN service on the FAT AP.
Figure 1-21 Network diagram for WLAN service configuration
IP network
L2 switch FAT AP
Client