H3C Technologies H3C Intelligent Management Center - Manual (Page 10)

5
NOTE:
With a password configured, you are asked to enter the password when adding a new IMC probe.
If you do not want to use a password, enter n when you see the message Do you want to set a
password for probe.
When the installation is complete, restart the server.
Figure 6 Installation complete
NOTE:
You must restart the server before the IMC probe can work normally. The IMC probe runs automatically after
the server is restarted. You can use the ps -ax | grep probe command to confirm that the probe process
is running.
If errors occur during installing the Red Hat Enterprise Linux Server 6.4 server, see " 3 FAQ " for solutions.
Uninstallation
1. Delete the unba directory under the directory where the IMC probe is installed.
# cd /usr/local/unba
# rm -rf *
2. Delete the /opt/unba_data directory.
# rm -rf /opt/unba_data
3. Delete the /data directory.
# unlink /data
4. Delete the probe services.
# chkconfig --del probed
5. Delete the /etc/probed file.
# cd /etc/init.d
# rm -rf probed
6. Open the /etc/probe file with the vi command and delete information about the probe.
# vi /etc/profile
7. Restart the server after removing the IMC probe.