H3C Technologies H3C Intelligent Management Center - Manual (Page 11)

6
3 FAQ
How can I launch the IMC probe manually after the installation?
To launch the IMC probe manually, perform the following operations:
1. Enter the unba directory under the directory where the IMC probe is installed.
2. Enter the bin subdirectory.
3. Execute the ./monitor command.
How can I manually stop the IMC probe?
To manually stop the IMC probe, perform the following operations:
1. Enter the unba directory under the directory where the IMC probe is installed.
2. Enter the bin subdirectory.
3. Execute the ./monitor stop command.
How can I solve the prbkern.ko error during the installation of the IMC probe in the Red Hat Enterprise
Linux Server 6.4 server?
Figure 7 shows the error.
Figure 7 Failing to install the IMC probe
The error results from the lack of software packages required for installing the IMC probe.
To resolve the problem, use one of the following solutions:
Solution 1
1. Re-install the operating system (see Red Hat Enterprise Linux Server 6.4 Installation Guide).
2. Customize the software settings.
3. Install the IMC probe on the server.