H3C Technologies H3C Intelligent Management Center - Manual (Page 152)

Topology operations
Viewing device VPN information
1. Right-click a PE device.
2. Select L2VPN Info from the shortcut menu.
The page for the L2VPN information appears. For information about L2VPN information, see
"
Viewing L2VPN information on a PE ."
Viewing PW information
1. Right-click the PW between two PEs.
2. Select PW Info from the shortcut menu.
The page for the PW information appears. You can view the PW connectivity status, left device,
right device, PW type, PW encapsulation type, and failure reason on the page.
Auditing a VPN
1. Right-click the blank and select Audit from the shortcut menu.
The message Start VPN Auditing is displayed in the log area below the topology. After a period
of time, you can view the audit results in the VPN List.
Application
In this chapter, PEs are H3C S95 and S75 series switches.
Configuration commands executed on the devices depend on the device model and software version. For
more information about the commands in this chapter, see the manual for the device.
Managing an BGP VPLS VPN
Network requirements
As shown in Figure 32 , a customer has two sites CE 1 and CE 2 that connect to PE 1 and PE 2 through
VLAN 100. Configure an LDP VPLS VPN so that the customer sites can communicate in VLAN 100 over
the MPLS network.
142