Grass Valley 8920ADC v.2.0.1A - Manual (Page 25)

8920ADC Instruction Manual 25
Configuration
• Left and Right Channel Levels – fine gain adjustment of the module
output levels can be done with the
Left and Right Channel Level controls.
Coarse gain levels must first be set up using the on-board jumpers JP5
and JP6 as described in
Remote Configuration and Monitoring on page 19 .
Follow the procedures given there for adjusting the output levels using
the fine gain adjustments described below.
Adjust the fine gain in either Numeric or Sliders mode (Numeric mode
shown in Figure 10 .) The single arrows increment the value by 1x and
the double arrow will increment the value by approximately 10x. These
controls will allow you ± 6.0 dB of fine adjustment range.
Note In Numeric mode only, values selected with the single or double arrow keys
will be enabled immediately. All other display entries, including typed in
values, require pressing Apply before the selection is enabled.
Figure 10. 8920ADC Audio Control and Status Display