Grass Valley 8985FS v.1.3.2 - Manual (Page 22)

22 8985FSP/FS — Instruction Manual
Installation
Video Inputs
Connect an HD or SD digital video signal to the Coax input at BNC J9,
and/or to one or both of the fiber inputs at fiber connector J10 (depending
on the type of fiber submodule installed).
Note Refer to Table 3 on page 45 for important video input and external genlock
reference input video frame rate compatibility information.
For fiber optic inputs, a Dual Receiver (RX1 and RX2) or Transceiver (RX1)
SFP optical submodule must be installed. Fiber inputs must be enabled
with remote controls. Only one video input can be used at a time and must
also be selected with remote controls.
Video Outputs
There are four electrical coax video outputs at BNCs J5, J6, J7, and J8.
If a Transceiver SFP optical submodule is installed, one fiber optic output
(TX2) is also available. If a Dual Transmitter SFP optical submodule is
installed, two fiber optic outputs (TX1 and TX2) are also available. Each
fiber optic output must be enabled using local or remote controls. All coax
and fiber optic outputs can be active at the same time.
Genlock Loop
BNCs J1 and J3 are looping inputs to support the optional Genlock sub-
module on the 8985FSP/FS module with an external genlock reference
(NTSC/PAL color black or Tri-level sync). Refer to
Table 4 on page 61 for a
table of compatible frame rates for installing the external genlock reference.
Connect an external reference to J1 or J2 and loop the other input to another
device or terminate the unused input.
Auto Tracking Delay Outputs
BNCs J1 and J3 output an auto tracking delay signal that can be fed to audio
modules to synchronize the audio to the Genlock reference from the
8985FSP/FS module.