Grass Valley iTX SmartClient v.2.6 - Manual (Page 51)

43
iTX SmartClient
Operator Guide
The start time is shown as the time the button was double clicked, minus the in-point offset
handle. E.g. If the event is started at 10:00:00:00, but the in-point offset is 10 seconds, then
the start time of the event will show as 09:59:50:00.
The same is applied to the out-point, when the user clicks to end the event.
In addition to this, offset handles can now be configured in the logging template to be up
to 600 seconds instead of the previous 100.
Deleting Events from the Scratchpad
Events can be deleted from the system completely via the scratchpad (below the logging
buttons), rather than just removed from the scratchpad itself, by clicking the on the top
right hand side of the scratchpad dialog for each event.
If you wish to simply remove the dialog from the scratchpad after annotating an event, you
now click the button.
This has made deleting unwanted events much easier than before. Previously, clicking the
button only removed the event from the scratchpad.