Removing and replacing frus, Chapter 5 – Grass Valley K2 Summit Client Service Manual Nov.23 2009 User Manual
Page 91
12 October 2009
K2 Summit Production Client Service Manual
91
Chapter
5
Removing and replacing FRUs
Field Replaceable Units (FRUs) are modular hardware components that can be
serviced without disturbing other components in the system. The following topics
discuss working with the K2 Summit Client FRUs:
•
•
The pictures in these topics show how to disassemble. Unless otherwise documented,
re-assembly is the reverse.
Unless otherwise indicated, you need only a Torx tool with T15 magnetic tip to
remove and replace parts in the K2 Summit Client.
NOTE: Only Grass Valley components are supported. Do not attempt to use
components procured from a different source.
NOTE: Do not discard any hardware unless specifically instructed to do so.
WARNING: To avoid serious injury from high currents, ensure that
both power cords are disconnected prior to removing or replacing any
parts.
CAUTION: This system contains board-level components that must be
protected from static discharge and physical shock. Wear a wrist strap
grounded to the system chassis when handling system components.
!
!