Grass Valley NV9654 v.1.1 - Manual (Page 73)

63
NV9654
User’s Guide
See also Back .
Hold
The ‘Hold’ button is a toggle. Press it once to activate “hold” mode, press it again to deactivate
“hold.” The button is high-tally when hold mode is active and low-tally when it is not.
You can activate or deactivate hold mode at any time during an MD selection or a breakaway
selection in X-Y mode. Your selection remains intact and the panel subsequently operates in
hold mode or non-hold mode according to the hold button state.
The default button text is “Hold Preset” but the button can have any legend.
Hold in MD Mode
In MD mode, turning hold mode on allows you to select more than one destination button at a
time. When you select a source, the source applies to all selected (high-tally) destinations. If hold
is still on when you press ‘Take’, the selected destinations remain selected and the display
reflects the selected destinations. The buttons for the selected destinations remain high-tally.
Without hold enabled, the panel has no destinations selected after an MD take and the buttons
for the selected destinations go low-tally.
When hold is active, all selected MD destinations get the source you selected most recently (in
case you change your mind and selected another source).
Hold in X-Y Mode
In X-Y mode, the hold button causes breakaway levels to be retained after a take. The levels you
selected (and deselected) remain lit (or unlit) as they were before the take.
Information
The ‘Information’ button presents auxiliary information on the alphanumeric display. Such infor-
mation might be level-mapped sources.
The default button text is “Info” but the button can have any legend.
Level Map
The ‘Level Map’ button cross-connects levels (typically in the same physical router). The function
is typically used to shuffle audio channels, for example, to connect AES1/2 to AES3/4.
Follow these steps to create a level mapping: