Grass Valley PFR 500/E Dec 10 2001 - Manual (Page 54)

Chapter 3 Servicing and upgrading a PFC500/E
54 PFC500/E Instruction Manual November 17, 2000
Installing or removing the RC memory module
Although you RC is equipped with the required amount of memory, you may need to
upgrade the memory in the future. Use these instructions to remove or add memory
modules.
To install or remove an RC memory module
1. Read the “Avoiding electrostatic discharge (ESD) damage” section
(page 44).
2. Attach the clip of the ESD wristband to any bare (unpainted) metal on the PFC 500/
E chassis; then put the wristband around your wrist with the metal button against
your skin.
3. Remove the memory module (or the new RC board and memory module) from its
packaging, and place it on a static-free work surface.
4. If you are upgrading an RC, remove the RC from the chassis (page 52) and place
it on a static-free work surface.
5. On the RC, remove and/or install the DIMM in the appropriate connector as shown
next.
IMPORTANT: A memory module has a notch on its edge near pin 1 so that you can
insert it only one way.