Polaris 2013 ATV Sportsman 500 Tractor INTL - Manual (Page 44)

42
OPERATION
Break-In Period
The break-in period for your new POLARIS Tractor is the first ten hours
of operation, or the time it takes to use the first two full tanks of gaso-
line. No single action on your part will increase the life and performance
of your Tractor more than following the procedures for a proper break-
in. Careful treatment of a new engine and drive components will result
in more efficient performance and longer life for these components.
Do not operate at full throttle or high speeds for extended periods during
the first three hours of use.
Engine and Drivetrain Break-in
1. Fill the fuel tank with the recommended fuel. See page 27.
2. Check the engine oil level. See page 74. Add oil if necessary.
3. Select an open area that allows room to familiarize yourself with
vehicle operation and handling.
4. Drive slowly. Vary the throttle positions. Do not operate at sustained
idle.
5. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 43.
6. Pull only light loads.
7. Change both the oil and the filter at 25 hours or one month, which-
ever comes first.
8. Check fluid levels of transmission and all gearcases after the first 25
hours of operation and every 100 hours thereafter.
PVT Break-in (Clutches/Belt)
Break in the clutches and belt by operating at slower speeds during the
break-in period as recommended. Pull only light loads. Avoid aggres-
sive acceleration and high speed operation during the break-in period.
If a belt fails, always clean away all debris when replacing the belt.