Polaris 2016 600 Rush PRO-S - Manual (Page 145)

143
MAINTENANCE
Battery (if equipped)
Battery Installation
8. Connect and tighten the black (negative) cable last.
CAUTION! Verify the battery cables and wiring harness do not come into
contact with the brake disc. Move the wiring harness/cables behind the chassis
tube and away from the brake disc.
IMPORTANT: Route the
BROWN harness ground wires
(A) and BLACK main battery
ground cable (B) as shown in
the image. Both are routed up
and over the rubber strap. If
the ground wires/cable are
routed down the side of the
battery, they may interfere with
the rear side panel tab. Note
the routing of the RED
(positive) battery cable (C) and that the right fender (D) is pulled away
from the chassis. Item (E) is the constant power fuse connector.
9. Verify that cables are properly routed.
NOTICE: Ensure that the battery wires are routed in such a way that they
cannot come into contact with the brake disc.
10. Secure the right fender using the plastic rivet.
11. Reinstall the console using the two plastic rivets.
12. Reinstall the side panel.