Polaris 2016 600 Rush PRO-S - Manual (Page 87)

85
OPERATION
Break-In Period
Engine Break-In
The recommended break-in period is the time required to use the first
full tank of pre-mixed fuel.
Excessive heat build-up during the first three hours of operation will
damage close-fitted engine parts. Do not operate at full throttle or high
speeds for extended periods during the first three hours of use. Vary the
throttle openings and vehicle speeds to reduce friction on all close-
fitting machined parts, allowing them to break in slowly without
damage.
The engine management system utilizes both a fuel injector break-in
period and oil pump enrichment program. The duration of these break-in
programs is independent of each other and is timed out based on engine
run time. Regardless of these automatic engine break-in and enrichment
features, the following engine break-in procedures must be performed
when the engine is new or overhauled.
NOTE: During this period of increased oiling, sled performance will not be
affected and you should ride normally.
Premix the first tank of fuel and fill the oil reservoir as outlined below.
Oil added to the fuel and oil injection systems will provide the necessary
engine lubrication.
See page 149 for the part numbers of POLARIS products.
Break-In Function Engine
Run Time
Description
Fuel Injectors 2 Hours Additional fuel
600 Models Oil Pump Enrichment Period 5 Hours
Enriched oil supply
to engine
800 Models Oil Pump Enrichment Period 18 Hours
Oil Recommendations
First Tank of Fuel: POLARIS VES 2-Cycle Oil
After Break-in: POLARIS VES 2-Cycle Oil
Extreme Arctic Conditions, sustained
temperature is at or below -40° F (-40° C)
VES RACE 2-Cycle Oil