Features and controls, Batteries – Polaris 2015 GEM eM1400 LSV User Manual
Page 28
26
FEATURES AND CONTROLS
Batteries
This vehicle is equipped with eight 6-volt batteries that supply the power needed to operate
the vehicle. The batteries are located under the seat. See page 63 for battery access
instructions.
Always observe all battery safety warnings and safe handling procedures as outlined on
vehicle safety labels and in this manual. Refer to the battery maintenance section beginning
on page 62.
Battery Handling Precautions
• Always make sure that all electrical accessories are grounded directly to the negative (-)
post on the terminal board. Never use the chassis or body as a ground connection.
• Always keep battery terminals and connections clean and free of corrosion at all times.
See page 64.
• Always maintain a full charge on the batteries. For best battery life, avoid discharging the
batteries more than 80%. See page 20.
• Make sure new batteries are fully charged before using.
• New deep cycle batteries need to be cycled several times before reaching full capacity (50-
125 cycles, depending on type). Capacity will be limited during this time.
• Make sure vent caps are installed properly and securely during vehicle operation and
battery charging.
• Recharge batteries fully at the end of each day the vehicle is operated, allowing adequate
time for the charger to complete its charge cycle. The batteries in this vehicle do not have
a “memory effect”. Frequent charging will extend their life.
• Avoid charging at temperatures above 120° F. (49° C.) ambient air temperature. Closed,
unvented storage buildings often exceed this temperature when exposed to direct sunlight.
• Never connect an auxiliary battery to the factory-installed DC-to-DC converter. If more
than 10 amps are needed for accessories, always install the GEM-approved auxiliary
accessory battery kit.
• Never connect a 12-volt accessory directly to the batteries. Always connect any powered
accessory to a 12-volt auxiliary outlet or terminal board. See page 20.
• Never connect jumper cables to any of the batteries of this vehicle.
• Use only insulated tools when working in the battery compartment.